Description
Earthing cable for safe earthing and discharge of shielding textiles, shielding fleeces as well as loosely laid building fabrics.
Transparent earthing cable with attached snap fastener for permanent wiring
The earthing cable consists of a 3.5 metre long transparent earthing cable with a push button and a wire end sleeve attached to each end.
The push button has an enlarged contact surface and is attached to the shielding material as shown in the picture.
The ferrule attached to the end of the cable is used for fixed wiring at the designated points in the electrical installation (socket, fuse box, FPA rail).
IMPORTANT!
ATTENTION:The necessary installation must be carried out by a qualified electrician. A residual current circuit breaker (FI, RCD ≤ 30mA) must be present in the circuit. This device is a standard part of every electrical installation and will be installed by your electrician if not available.
All electrical work (work on electrical devices and systems) must be carried out and checked by a qualified electrician or under their direction and supervision!
Use your line only in normally tempered, dry indoor rooms.
Do not use outdoors!
Colour: transparent
Length: 350 cm
Push-button diameter Ø outside: 25 mm
Push-button diameter Ø inside: 12 mm
Cross section 2,5 mm²
Range of application: Suitable for home textiles as well as high and low frequency shielding fleeces
Scope of delivery
1. earthing cable incl. attached cable eyelet and push-button top part
2. push-button base for anchoring in the shielding material
Instructions for use
Installation is simple. Simply bend the tips of the lower part of the push-button downwards by 90° and gently push them through the shielding material; Then bend the tips again by 90° to permanently attach the lower part of the press stud to the screen material.
After gluing the protective pad supplied onto the folded spikes, connect the upper part of the pushbutton to the fixed lower part.
The free end must be connected to the potential equalisation by a qualified electrician.
To do this, the plug insert is removed and the open end is inserted into the appliance socket and connected to the PE terminal.
The socket can then continue to be used for electrical consumers.
